Telecontrol Gateway / RTU Reference Design
Illustrative reference design of a telecontrol / data communication gateway mainboard for the station level of a substation: the processor collects MMS data from protection and control devices through dual A / B 100M station-bus ports, reports to the dispatch master station via IEC 60870-5-104 through two Gigabit dispatch data network ports (via vertical encryption devices), and connects legacy serial devices (IEC 60870-5-101 / 103) through four isolated RS-485 ports; it is deployed as a redundant pair on dual networks, with the two gateways acting as main and standby. Each position is marked with the VOOHU part available, recommended part numbers and package pinout.
Illustrative PCB ⇄ Schematic
Illustrative top-side view arranged by functional zone (not the actual layout). Red numbered dots mark positions VOOHU can supply. Click a component on the board, an entry in the index below or a part in the schematic to see recommended parts and package pinouts on the right.
Station bus network A reference topology: the processor connects over RMII to 10/100 PHY U4 (JL1111B-NI), then through ESD D1 (WHALD03G4U) and VOOHU single-port LAN transformer T1 (WHS16037TG) to RJ45 J1; the cable-side center tap goes to chassis ground through 75Ω×2 + 1nF/2kV and the PHY-side center tap to ground through 0.1µF. Only 1 differential pair is drawn; the PHY crystal, series resistors and decoupling are omitted.
Board bill of materials
Summarized by position; click any row to locate it on the board above.
| No. | Zone | Position | Ref. | VOOHU category | Recommended part | Availability |
|---|---|---|---|---|---|---|
| 01 | A Station Bus A / B | RJ45 port (station bus network A) | J1 | RJ45 Connectors | SYT561188GWA3DY1027 | VOOHU |
| 02 | A Station Bus A / B | 10/100 LAN transformer (network A) | T1 | LAN Transformers | WHS16037TG | VOOHU |
| 03 | A Station Bus A / B | Station bus network A ESD array | D1 | TVS / ESD | WHALD03G4U | VOOHU |
| 04 | A Station Bus A / B | 10/100 Ethernet PHY (network A) | U4 | Ethernet PHY | JL1111B-NI | VOOHU |
| 05 | A Station Bus A / B | RJ45 port (station bus network B) | J2 | RJ45 Connectors | SYT561188GWA3DY1027 | VOOHU |
| 06 | A Station Bus A / B | 10/100 LAN transformer (network B) | T2 | LAN Transformers | WHS16037TG | VOOHU |
| 07 | A Station Bus A / B | Station bus network B ESD array | D2 | TVS / ESD | WHALD03G4U | VOOHU |
| 08 | A Station Bus A / B | 10/100 Ethernet PHY (network B) | U5 | Ethernet PHY | JL1111B-NI | VOOHU |
| 09 | B Dispatch Network ×2 | RJ45 port (dispatch network 1) | J3 | RJ45 Connectors | SYT561188GWA3DY1027 | VOOHU |
| 10 | B Dispatch Network ×2 | Gigabit LAN transformer (dispatch 1) | T3 | LAN Transformers | WHSG24002TG | VOOHU |
| 11 | B Dispatch Network ×2 | Dispatch network 1 ESD array | D3 | TVS / ESD | WHALD03G4U | VOOHU |
| 12 | B Dispatch Network ×2 | Gigabit Ethernet PHY (dispatch 1) | U6 | Ethernet PHY | JL2101C-NI | VOOHU |
| 13 | B Dispatch Network ×2 | RJ45 port (dispatch network 2) | J4 | RJ45 Connectors | SYT561188GWA3DY1027 | VOOHU |
| 14 | B Dispatch Network ×2 | Gigabit LAN transformer (dispatch 2) | T4 | LAN Transformers | WHSG24002TG | VOOHU |
| 15 | B Dispatch Network ×2 | Dispatch network 2 ESD array | D4 | TVS / ESD | WHALD03G4U | VOOHU |
| 16 | B Dispatch Network ×2 | Gigabit Ethernet PHY (dispatch 2) | U7 | Ethernet PHY | JL2101C-NI | VOOHU |
| 17 | C Isolated RS-485 × 4 | RS-485 terminals ×4 (serial protocols) | J5 | — | — | Non-VOOHU |
| 18 | C Isolated RS-485 × 4 | RS-485 GDT ×4 | GDT1 | GDT | WHGT090V1P0A | VOOHU |
| 19 | C Isolated RS-485 × 4 | RS-485 CMC ×4 | L1 | Signal Line CMC | WHAC-4532A-510U0 | VOOHU |
| 20 | C Isolated RS-485 × 4 | RS-485 ESD / TVS ×4 | D5 | TVS / ESD | WHALD30E2B | VOOHU |
| 21 | C Isolated RS-485 × 4 | Isolated RS-485 transceiver ×4 | U8 | — | — | Non-VOOHU |
| 22 | C Isolated RS-485 × 4 | Push-pull driver + rectifier / LDO | U9 | — | — | Non-VOOHU |
| 23 | C Isolated RS-485 × 4 | Push-pull isolation transformer | T5 | Push-Pull Transformers | WHST06Q06A0 | VOOHU |
| 24 | D Processor | Processor (protocol conversion + failover) | U1 | — | — | Non-VOOHU |
| 25 | D Processor | DDR memory | U2 | — | — | Non-VOOHU |
| 26 | D Processor | eMMC storage | U3 | — | — | Non-VOOHU |
| 27 | E 24 V power | 24 V power input (device power module) | J6 | — | — | Non-VOOHU |
| 28 | E 24 V power | Input power-line common-mode choke | L2 | Power Line CMC | WHAL-7060A-701T0 | VOOHU |
| 29 | E 24 V power | Buck converter (24 V → 5 V) | U10 | — | — | Non-VOOHU |
| 30 | E 24 V power | Buck converter (5 V → 3.3 V / core) | U11 | — | — | Non-VOOHU |
| 31 | E 24 V power | Molded inductors ×2 (DC-DC) | L3 L4 | Molded Inductors | WHYT0630 Series | VOOHU |
Resources & downloads
Board bill of materials
Reference designators, zones, VOOHU categories, recommended parts and availability for all 31 positions. Opens directly in Excel.
Datasheet collection
Datasheet PDFs for the VOOHU parts recommended on this board.
Design files & footprint library
Schematic, PCB, and VOOHU part footprints and 3D models.
Coming soonRequest the full telecontrol gateway reference design packagefull package
Includes the board position list, datasheets of recommended VOOHU parts and per-position selection notes. For advice on your Ethernet port count, serial channel count or dispatch protocols, describe them in the request. We reply within 24 hours on working days.