News Center

Starting from the public on-shelf material numbers of SFP+ and SFP28 optical cages, we sort out the board-level verification boundaries of Press-Fit holes and tooling, light guide configurations, heat dissipation holes, and chassis assembly.

From the five levels of interface working point, public material number field, schematic diagram, layout and joint debugging, it explains how the audio isolation transformer avoids ground loops, impedance mismatching and board-level re-coupling.

VOOHU WH291Z02SD0S02 versus Pulse SFPPCAGE011-L: SFP+ 1×1 cage comparison.

For industrial gateways, wireless APs, edge computing terminals and embedded switching equipment, the port number, packaging, PoE boundary, PHY matching and PCB verification methods of 2.5G/5G Ethernet transformers are explained.

For outdoor cabinets, industrial gateways, security front-ends and field collection equipment, the panel sealing, matching plugs, IP65/IP67 boundaries, chassis grounding and prototype verification methods of waterproof RJ45 are explained.

Comparison of SFP 1×1 cage parameters between VOOHU WH191R02SD0S02 and Pulse SFPCAGE002-L and considerations for alternative selection.

Comparison of SFP+ 1×4 cage parameters between VOOHU WH294T459D0S02 and Amphenol U77-A461M-X081 and considerations for alternative selection.

For PLC, servo drives, test equipment and industrial control cabinets, the system describes the pin partitioning, shielding grounding, ESD protection, PCB layout and on-shelf material number selection boundaries of the D-SUB interface.

The integrated network port (Mag-Jack) integrates the network transformer, common mode inductor, Bob Smith termination and indicator light inside the RJ45. Its pins include differential pins, center taps, NC, GND, LED and other different functions, and the connection methods are different. Most of the three types of problems, such as network port failure, indicator light not lighting, and EMC failure, are not damaged components, but incorrect pin wiring. VOOHU Electronics (VOOHU) explains these three types of common wiring errors in four parts: phenomenon, root cause, correct approach, and sel

How to implement 5-port and 8-port unmanaged switches? Should I choose 100M or 1000M switching chips? How many ports? The chip integrates PHY. Does the network port require a network transformer? Why can't we negotiate as soon as the power is turned on? Why is it that the EMC test exceeds the standard? Why does the ESD sound fail after being hit? VOOHU explains the selection logic from the physical layer structure of the switching chip, analyzes the trade-off between integrated magnetic RJ45 and discrete network transformers, and provides a selection table and FAQ for on-rack switching ch

One cable carries both power and data, yet the PD-side isolated supply is where designs overheat, ripple, and fail hi-pot. This guide walks the PoE chain and shows how to size the flyback transformer and pick the right VOOHU PoE power transformer by 802.3af/at/bt class.

Industrial port "fine cold, drops hot"? This article shows how temperature changes LAN-transformer OCL/DCR and choke impedance, with a -40 to +85 °C wide-temperature derating method and a VOOHU industrial-grade selection table.