Samples
Samples are available for evaluation, and selected parts are free of charge. Our FAE team will be glad to confirm the options for your project.
Get a Quote or Samples →Single-port 10GBASE-T LAN transformer (Ethernet transformer): 24-pin SMD, 1500 Vrms isolation, not PoE rated. Operating temperature −40 to +85 °C.
Buy Online
When you click Get a Quote or Samples or Add to Inquiry, part number WHSM24P02N0 is filled in automatically.
Leave your details and we will send a tailored volume quote.
Our sales team will contact you within 1 business day.
Reach our sales team for pricing and lead time.

We have received your request. Our sales team will contact you within 1 business day.
01Specifications
Values from published data for this part (parameters, FAQ and evaluation report). The datasheet prevails.
02Cross reference
VOOHU WHSM24P02N0 can replace Pulse Electronics H7008NL. See the evaluation reports below for details.
Based on VOOHU replacement evaluations. Check both datasheets and validate with samples before switching.
03Applications
The transformer isolates the PHY from the cable and couples the TX and RX differential pairs to the RJ45 jack.
Center-tap biasing on the PHY side depends on the PHY type (voltage-mode or current-mode).
Typical application for reference. Follow the PHY vendor's reference design.
Reference designs by application:Industrial ControlSecurity MonitoringData Communication
04Documents
05Quality
ISO certificates cover VOOHU's management systems. RoHS and REACH test reports cover tested samples of each product family.
06Ordering
Samples are available for evaluation, and selected parts are free of charge. Our FAE team will be glad to confirm the options for your project.
Get a Quote or Samples →07Compare
Red marks values that differ from this part; data from the published parameters of each part.
08FAQ
No. The datasheet assigns no DC balance current capability to the centre taps of the WHSM24P02N0, so they cannot be used as a supply path. The WHSM24P02N0 handles signal transformation and isolation for a 10G BASE-T port, and power for the port has to come from the equipment itself.
If the port must run wide-temperature and also deliver power, move to a part that publishes a DC balance current figure, such as the WHSM24015T0. If the target current is higher than that part provides, send us the per-port current and temperature you need and we will reselect.
The WHSM24P02N0 suits industrial 10G data ports where the component temperature may fall anywhere between -40 °C and +85 °C. Typical uses are industrial switches, 10G uplinks inside outdoor enclosures, wide-temperature edge computing units and factory-floor gateways. The WHSM24P02N0 carries no PoE rating, so the port is powered by the equipment itself.
Note that -40 °C is the component's lower operating limit, not a demonstrated cold-start capability for the finished product – low-temperature power-up still has to be measured with the target PHY and cable. Other options are in the 10G BASE-T range.
On the criteria that drive selection the WHSM24P02N0 and the WHSM24P01N0 are interchangeable: both operate from -40 °C to +85 °C, share the same storage range, neither supports PoE, and the electrical block is the same. The one documented difference is in the reflow note.
The WHSM24P02N0 measures the dwell within 3 °C of the actual peak, where most parts in this speed class state 5 °C, so check your line profile against the tighter of the two. Where both parts qualify, decide on availability and on what is already in the bill of materials.
09Support
REQUEST TYPE
An engineer will contact you within 1 business day using the details you provided.
Typical application