Dual-Spectrum Thermal IP Camera Reference Design
Illustrative main-board design of an outdoor dual-spectrum (thermal + visible) IP camera for perimeter protection and campus / forest fire early warning: video is sent over Gigabit Ethernet (1000BASE-T) and the camera is powered over the same cable by IEEE 802.3at PoE+, or from DC 12V on the pigtail cable; the IPC SoC connects both an uncooled thermal imaging core and a visible-light CMOS sensor, and the pigtail brings out optically isolated alarm input / output, RS-485 (PTZ / peripheral control) and audio input / output. This page gives the function, selection notes and available VOOHU part numbers for 33 component positions.
Illustrative PCB ⇄ Schematic
The illustrative board shows the layout and component positions; click any position to view selection notes, recommended parts and packages. The board is arranged neatly by functional zone for illustration (not the actual layout) and shows only the camera main board; the RJ45 port and pigtail connector sit on the bottom edge, while the thermal imaging core and visible-light sensor board connect through the top connectors and are external nodes.
The 4 Gigabit Ethernet differential pairs are identical; only 1 pair is drawn. RJ45 J1 is a plain RJ45 without magnetics, coupled through the discrete Gigabit PoE+ LAN transformer T1 (WHSG24706-1PTG, PoE+ ≤ 720 mA); the PHY-side pairs are clamped by ESD arrays D1 / D2 (WHALD03G4U) before the Gigabit PHY U1 (JL2101C-NE), which connects to the IPC SoC over RGMII. The cable-side center taps of T1 deliver PoE power to the rectifier bridge (see the PoE+ PD chain), and gas discharge tube G1 diverts surges to chassis ground. Refer to the PHY datasheet for center-tap termination and crystal load capacitor values.
Board bill of materials
Click any row to jump to that position and view its selection notes
| No. | Zone | Position | Ref. | VOOHU category | Recommended part | Availability |
|---|---|---|---|---|---|---|
| 01 | A GbE RJ45 | RJ45 port (Gigabit · PoE+ PD) | J1 | RJ45 Connectors | SYT561188AB1A1DB4 | VOOHU |
| 02 | A GbE RJ45 | Gas discharge tube (cable side to chassis) | G1 | GDT | WHGD200V1P0B | VOOHU |
| 03 | A GbE RJ45 | Gigabit PoE+ LAN transformer | T1 | Gigabit LAN Transformers | WHSG24706-1PTG | VOOHU |
| 04 | A GbE RJ45 | Ethernet ESD array ×2 | D1 D2 | TVS / ESD | WHALD03G4U | VOOHU |
| 05 | A GbE RJ45 | Gigabit PHY (RGMII) | U1 | Ethernet PHY | JL2101C-NE | VOOHU |
| 06 | A GbE RJ45 | PHY 25MHz crystal | Y1 | — | — | Non-VOOHU |
| 07 | B PoE PD | PoE input bridge rectifier | D3 | — | — | Non-VOOHU |
| 08 | B PoE PD | PD input TVS | D4 | TVS / ESD | WHTB058VA | VOOHU |
| 09 | B PoE PD | PoE PD controller + flyback PWM | U2 | — | — | Non-VOOHU |
| 10 | B PoE PD | PoE flyback transformer | T2 | PoE Power Transformers | WH13P-12H5 | VOOHU |
| 11 | B PoE PD | Secondary synchronous rectifier | U3 | — | — | Non-VOOHU |
| 12 | B PoE PD | Feedback opto | U4 | — | — | Non-VOOHU |
| 13 | C Alarm · RS-485 · Audio | Pigtail connector (alarm · RS-485 · audio · DC 12V) | J2 | — | — | Non-VOOHU |
| 14 | C Alarm · RS-485 · Audio | Alarm I/O line ESD ×2 | D5 D6 | TVS / ESD | WHALD30E2B | VOOHU |
| 15 | C Alarm · RS-485 · Audio | Optically isolated alarm input | U5 | — | — | Non-VOOHU |
| 16 | C Alarm · RS-485 · Audio | Alarm output (PhotoMOS relay) | U6 | — | — | Non-VOOHU |
| 17 | C Alarm · RS-485 · Audio | RS-485 gas discharge tube (primary) | G2 | GDT | WHGT090V1P0A | VOOHU |
| 18 | C Alarm · RS-485 · Audio | RS-485 bus TVS (secondary clamp) | D7 | TVS / ESD | WHALD30E2B | VOOHU |
| 19 | C Alarm · RS-485 · Audio | RS-485 differential-line CMC | L1 | Signal Line CMC | WHAC-4532A-601ZP0 | VOOHU |
| 20 | C Alarm · RS-485 · Audio | RS-485 transceiver | U7 | — | — | Non-VOOHU |
| 21 | C Alarm · RS-485 · Audio | Audio input / output isolation transformers ×2 | T3 T4 | Audio Transformer | WHTT4001 | VOOHU |
| 22 | D Core · Dual-spectrum | Thermal imaging core connector | J3 | — | — | Non-VOOHU |
| 23 | D Core · Dual-spectrum | Visible sensor connector | J4 | — | — | Non-VOOHU |
| 24 | D Core · Dual-spectrum | Dual-spectrum IPC SoC (ISP · encoding · analytics) | U8 | — | — | Non-VOOHU |
| 25 | D Core · Dual-spectrum | DDR memory | U9 | — | — | Non-VOOHU |
| 26 | D Core · Dual-spectrum | SPI NAND Flash | U10 | — | — | Non-VOOHU |
| 27 | D Core · Dual-spectrum | SoC main crystal | Y2 | — | — | Non-VOOHU |
| 28 | D Core · Dual-spectrum | microSD card socket | J5 | SD Card Sockets | WHTF190T123101W | VOOHU |
| 29 | D Core · Dual-spectrum | Core supply filter molded inductor ×2 | L2 L3 | Molded Inductors | WHYTA0420 Series | VOOHU |
| 30 | E Power | Power-line CMC (DC 12V input EMI) | L4 | Power Line CMC | WHAL-7060A-102T0 | VOOHU |
| 31 | E Power | PoE / DC input ORing diodes | D8 D9 | — | — | Non-VOOHU |
| 32 | E Power | Synchronous buck ×3 (core / DDR / 3.3V) | U11 U12 U13 | — | — | Non-VOOHU |
| 33 | E Power | DC-DC molded inductor ×3 | L5 L6 L7 | Molded Inductors | WHYT0630 Series | VOOHU |
Resources & downloads
Board bill of materials
Reference designators, zones, VOOHU categories, recommended parts and availability for all 33 positions. Opens directly in Excel.
Datasheet collection
Datasheet PDFs for the VOOHU parts recommended on this board.
Design files & footprint library
Schematic, PCB, and VOOHU part footprints and 3D models.
Coming soonRequest the full Thermal Camera Reference Design packagefull package
Includes the BOM, datasheets of recommended VOOHU parts and position-by-position selection notes. For advice tailored to your power scheme, PoE power class, outdoor surge protection or pigtail interface, describe it in your request. We reply within 24 hours on working days.